By locking the guard closed, our range will prevent access to the machine till it has come to a safe stop for the operator, and when it is safe, a signal sent from the safety control circuit should activate the solenoid, unlocking the guard and allowing the guard to be opened.

It differentiates from the main competitors by the non-contact design, allowing a much longer life expectancy. There is no ruining, the actuation is smooth.

Moreover, some interlocking switches on the market do not integrate the safety position of the bolt/key, so another safety switch is required to detect the position of the door and prevent a restarting of the machine even if the interlocking has extracted the bolt/lock.

This range was especially designed to overpass the main mechanical switches limits, mainly in environments where you find: 

• heavy contamination,
• frequent washdown,
• high vibration,
• poor actuator/switch alignment.

• the guided and recognised bolt into the plate thanks to the coded electronic process ACOTOM3®,

• the double connector available, to ease the serial wiring, and facilitate the automatic serial locking,
• an energy saving mode, to avoid unnecessary consumption,
• a heating control (heat limit to 80°C).

• Vigilguard, stand alone, PL4e acc. to ISO 13849-1,
• Anaguard, non stand-alone.